Sec. 171.309 - General requirements.
The MLS is a precision approach and landing guidance system which provides position information and various ground-to-air data. The position information is provided in a wide coverage sector and is determined by an azimuth angle measurement, an elevation angle measurement and a range (distance) measurement. (a) An MLS constructed to meet the requirements of this subpart must include: (1) Approach azimuth equipment, associated monitor, remote control and indicator equipment. (2) Approach elevation equipment, associated monitor, remote control and indicator equipment. (3) A means for the encoding and transmission of essential data words, associated monitor, remote control and indicator equipment. Essential data are basic data words 1, 2, 3, 4, and 6 and auxiliary data words A1, A2 and A3. (4) Distance measuring equipment (DME), associated monitor, remote control and indicator equipment. (5) Remote controls for paragraphs (a) (1), (2), (3), and (4) of this section must include as a minimum on/off and reset capabilities and may be integrated in the same equipment. (6) At locations where a VHF marker beacon (75 MHz) is already installed, it may be used in lieu of the DME equipment. (b) In addition to the equipment required in paragraph (a) of this section the MLS may include: (1) Back azimuth equipment, associated monitor, remote control and indicator equipment. When Back Azimuth is provided, a means for transmission of Basic Data Word 5 and Auxiliary Data Word A4 shall also be provided. (2) A wider proportional guidance sector which exceeds the minimum specified in §§171.313 and 171.317. (3) Precision DME, associated monitor, remote control and indicator equipment. (4) VHF marker beacon (75 MHz), associated monitor, remote control and indicator equipment. (5) The MLS signal format will accommodate additional functions (e.g., flare elevation) which may be included as desired. Remote controls for paragraphs (b) (1), (3) and (4) of this section must include as a minimum on/off and reset capabilities, and may be integrated in the same equipment. (6) Provisions for the encoding and transmission of additional auxiliary data words, associated monitor, remote control and indicator equipment. (c) MLS ground equipment must be designed to operate on a nominal 120/240 volt, 60 Hz, 3-wire single phase AC power source and must meet the following service conditions: (1) AC line parameters, DC voltage, elevation and duty:
|